Precautions For Use - Kenwood GP-610A Instruction Manual

3. PRECAUTIONS FOR USE

9
Input power check
• Use the input power i n the range of the rated input voltage.
Single-phase 100, 120, 220, or 240 VAC +/- 10%, maximum 250 VAC, 50/60 Hz
• To change the rated input voltage, see the section of maintenance.
• Amb i ent tempe r a t u re and Iocat i on of i n s t a I I at i on
• Do not use the component at a high-temperature and high-humidi ty place
exceeding the r a t i n g .
•Do not use the component at a place where i s much dust and v i b r a t i o n .
• I f a noise source e x i s t s near the component, take the proper action.
• Before power on
• Complete connect ions before power on and check that the connect ions are
correct.
• Power on/off order should be as shown below.
• Do not replace the connector while power i s on.
GP-610A
GP-610D
This component
# Be s u r e to ground the GND t e r m i n a l of t h i s component and the GND
terminal of the controlled power supply.
mat be affected by external noise and r e s u l t in malfunction.
Controlled power supply
OFF
Without grounding, the component
- 5 -