Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita RP1800 Instruction Manual

ENGLISH
1. Adjusting knob
2. Lock lever
3. Stopper pole setting nut
4. Fast-feed button
5. Adjusting bolt
6. Stopper block
7. Depth pointer
8. Stopper pole
9. Nylon nut
10. Lock button
11. Switch trigger
12. Speed adjusting dial
13. Lamp
14. Shaft lock
15. Wrench
16. Workpiece
17. Bit revolving direction
18. View from the top of the tool
19. Feed direction

SPECIFICATIONS

Model
Collet chuck capacity
Plunge capacity
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbols
The followings show the symbols which may be used for
the equipment. Be sure that you understand their
meaning before use.
.............. Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Explanation of general view
20. Straight guide
21. Fine adjusting screw
22. Clamping screw (B)
23. Clamping screw (A)
24. Guide holder
25. More than 15 mm
26. Wood
27. Adjusting screw
28. Screws
29. Movable
30. When set to minimum opening
width
31. When set to maximum opening
width
32. Template guide
33. Lock plate
34. Bit
35. Base
36. Templet
RP1800/RP1800F RP1801/RP1801F
-1
)
END201-8
ENE010-1
ENF002-2
37. Distance (X)
38. Outside diameter of the templet
39. Clamping screw (C)
40. Trimmer guide
41. Guide roller
42. Dust nozzle
43. Clamping screw
44. Flat washer 6
45. Screw M6 x 135
46. Hole
47. Threaded part in the motor
48. Inside of the screw hole in the tool
49. Screwdriver
50. Limit mark
51. Brush holder cap
12 mm or 1/2"
0 - 70 mm
22,000
312 mm
6.0 kg
/II
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
guide
bracket
base
RP2300FC RP2301FC
9,000 - 22,000
6.1 kg
GEA012-3
9