N S Talling Printed Circuit Cards; Ram Pack; Co Protection Card; Sli Card - Samsung DCS COMPACT Installation Manual

SAMSUNG DCS
T E C H N I C AL MANUAL
PART 3. INSTALLING PRINTED CIRCUIT CARDS
Unpack and inspect each card before installing. Check for signs of physical damage. If any damage
is detected, do not attempt to install. Contact Samsung Technical Support immediately.
3.1 RAM PACK (Figure 3–2)
Select the appropriate type of RAM pack for the system. Make sure that the BACK UP switch is in
the OFF positon. Insert the RAM card in the KSU slot labeled RAM (see Figure 3–1). Push firmly in
the middle of the RAM pack to ensure that it is fully inserted into the back plane connector.
To prevent accidental damage to the RAM card, the RAM connector on the back plane is positioned
to mate only with the RAM card. Other interface cards will not mate with this connector and the RAM
card will not mate with any other connector.
3.2 4 CO PROTECTION CARD (Figure 3– 3 )
This card has no selectable options. Insert the 4 CO protection card into the appropriate slot (see
Figure 3–1). Push firmly in the middle of both card ejectors to ensure that it is fully inserted into the
back plane connector.
3.3 2 SLI CARD (Figure 3– 4 )
This card has no selectable options. Insert the 2 SLI card into the appropriate slot (see Figure 3–1).
Push firmly in the middle of both card ejectors to ensure that it is fully inserted into the back plane
c o n n e c t o r.
3.4 MISC CARD (Figure 3– 5 )
There are no options to select on this card. Insert the MISC card into the appropriate slot (see Figure
3-1). Push firmly in the middle of both card ejectors on each card to ensure that it is fully inserted
into the back plane connector.
N O T E : Only one MISC card can be installed in a system.
3.5 4 TRK CARD (Figure 3–7)
There are no options to select on this card. Insert the 4 TRK card into any slot on the expansion
back plane (see Figure 3–6). Push firmly in the middle of both card ejectors on each card to ensure
that it is fully inserted into the back plane connector.
3.6 6 DLI CARD (Figure 3–7)
There are no options to select on this card. Insert the 6 DLI card into any slot on the expansion back
plane (see Figure 3–6). Push firmly in the middle of both card ejectors on each card to ensure that it
is fully inserted into the back plane connector.
3–1
INSTALLATION
A P R I L 1 9 9 6