Key Frame Effect Timeline Status Display – 610
9-10
Chapter 9 Status Displays
3
To change the length of the section displayed (i.e. the scale),
adjust the right knob ("Width").
Displaying the whole of a key frame effect on the
timeline – F2 (VIEW ALL)
Use the following procedure.
1
Set F1 (EXPAND) to "ON".
2
Press F2 (VIEW ALL).
This adjusts the time scale so that the whole key frame effect
is visible on the timeline.
Setting a pause position – F3 (PAUSE)
This determines the position at which the effect stops after
execution.
A maximum of eight pause positions can be set. ("Multi-pause"
function)
Notes
• The pause setting is only effective when you execute the effect
using the RUN button on the control panel or by a GPI trigger.
When executing an effect under the control of a DVS-6000/
6000C/7000 switcher system using the key frame link function,
or from an editor, the pause setting is ignored.
• When used together with a switcher system which does not
support the multi-pause function (DVS series), only one pause
position can be set.
1
Select the channel or channels to which the setting is to apply.
2
Stop the effect at the desired pause position.
3
Press F3 (PAUSE).
This sets the pause.
Clearing the pause setting
Stop the effect at the currently set pause position, and press F3
(PAUSE).
This clears the pause setting.