Figure 6-5 Transceiver Removal From The Back Card; Removing And Installing Back Card Transceivers; Remove The Back Card Transceivers - Cisco MGX MGX 8800 Hardware Installation Manual

Removing and Installing Back Card Transceivers

Removing and Installing Back Card Transceivers
The following sections describe how to remove and install a back card transceiver.
It is recommended that you label each cable and wire at both ends to identify its source and destination.
Tip
Caution Proper ESD protection is required whenever you handle Cisco equipment. Wear a grounding strap to
eliminate the risk of ESD damage to the equipment. Modules are subject to ESD damage whenever they
are removed from the chassis.

Remove the Back Card Transceivers

Complete the following steps to remove transceivers from the back cards:
Connect a grounding strap to the ESD grounding jack.
Step 1
Mark and disconnect all cables and wires from the back card.
Step 2
Push the pink extraction ring around the transceiver toward the back card, as shown in
Step 3
1).
Figure 6-5
Cisco MGX 8800/8900 Series Hardware Installation Guide
6-12
Transceiver Removal from the Back Card
2
Chapter 6 Maintaining the Cisco MGX Switch or Gateway
1
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Figure 6-5 (callout