Figure 5-70 Front Card Extractor Lever - Cisco MGX MGX 8800 Hardware Installation Manual

Chapter 5 Installing the Cisco MGX Switch or Gateway
Figure 5-70
Left side or
top of card
Pull the extractor lever(s) to disconnect the front card from the midplane.
Step 6
Gently pull the front card out of the card cage. Keep the front card level and make sure that it does not
Step 7
hit the one beneath it.
Step 8 Place the front card in an antistatic bag or on an antistatic bench.
Repeat
Step 9
Remove the Back Cards
Complete the following steps to remove back cards from the chassis.
Caution Do not use a power screwdriver on captive screws.
Record the location of all of the cards before you remove them.
Step 1
Use the flat-head or Phillips tip of the 3-in-1 tool to loosen the two captive screws located on the left and
Step 2
right of the back card faceplate.
Pull each of the two extractor levers, located at the left and right of the faceplate, out to the horizontal
Step 3
position.
Step 4 Pull evenly on the two extractor levers to remove the back card from the card cage.
Step 5 Place the back card in an antistatic bag or on an antistatic bench.
Repeat
Step 6
Remove the Back Cards from an APS Assembly
Complete the following steps to remove back cards from an APS assembly and to remove the APS
connector from the switch.
An APS assembly consists of two back cards, a primary card and a secondary card, which are connected
Note
by an APS connector (Cisco Part Number MGX-8830-APS-CON).
Do not use a power screwdriver on captive screws.
Caution
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Front Card Extractor Lever
Slot
Step 5 through Step 8 for each front card that you are removing from the chassis.
Step 2 through Step 5 for each back card that you are removing from the chassis.
Installing the MGX 8830 or MGX 8830/B Switch
Cisco MGX 8800/8900 Series Hardware Installation Guide
5-111