Cisco MGX 8850 Command Reference Manual page 460

cnfpnportsig
-nniver
-unitype
-addrplan
-side
-vpi
-sigvci
-rccvci
-cntlvc
Cisco MGX 8850 Routing Switch Command Reference
6-42
The NNI version: iisp30, iisp31, pnni10, or enni. Note that univer and nniver are
mutually exclusive—so the interface at each end of the connection must have the
same interface type. Also, the port type on the PNNI controller must be the same as
on the slave (through addport ... ifType on the AXSM, for example).
The default for this parameter is PNNI 1.0. If this version is sufficient, you can forego
this parameter. However, to change an NNI version, the port must be down.
Remember to up the port by using the uppnport command after completing the
cnfpnportsig command.
Default: pnni10
The type of UNI is either private or public. This parameter is relevant only if you
specified a UNI interface through the -univer parameter.
Default: private
The address plan of the calling party that the interface accepts. The choices are both,
e164, and aesa. The default is both.
Only a public UNI can use this parameter. For all other interface types, the port
automatically accepts either AESA or E.164 address plans.
The side of the port: type "user" or "network." This parameter applies to IISP only
and public UNI. (An NNI interface type automatically is "network.")
An IISP or public UNI has a user side and a network side. (If both sides are the same,
a configuration error has occurred.) The network side is the side that assigns the VPI
and VCI. These links do not distinguish between SVCs and SPVCs.
Default: network
The VPI of the signaling and routing control channel (RCC) on the port.
Range: 0–4095
Default: 0
The signaling VCI for the port. If you do not use the default of 5, this VCI must be in
the range 32–65535.
Range: 5 or 32–65535
Default: 5
The routing control channel-vci: the VCI for PNNI RCC. If you do not use the default
of 18, this VCI must be in the range 32–65535.
Range: 18 or 32–65535
Default: 18
Enable for an IP-based signaling channel. This option applies only to a feeder
connected to the switch. An IP-based control channel is mutually exclusive of either
UNI or NNI. The only choice for -cntlvc is "ip."
Default: "ip" (for Internet Protocol)
Chapter 6 Logical Node, Port, and Signaling Commands
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001