Chapter 4
Transceiver Modules
Step 3
Additional Guidelines
78-18039-02
Use a magnifying glass or inspection microscope to inspect the ferrule at an angle.
Do not look directly into the aperture. Repeat the process if any contamination is
detected.
The connectors used inside the system have been cleaned by the manufacturer and
connected to the adapters in the proper manner. The operation of the system
should be error free if the customer provides clean connectors on the application
side, follows the previous directions, and follows these guidelines:
Clean the connectors using either a CLETOP cassette cleaner (Type A for SC
•
connectors and Type B for MT-RJ connectors) or lens tissues before
connecting to the adapters. Use pure alcohol to remove contamination.
Do not clean the inside of the connector adapters.
•
Do not use force or quick movements when connecting the fiber-optic
•
connectors in the adapters.
Cover the connectors and adapters to keep the inside of the adapters or the
•
surface of the connectors from getting dirty when you are not using the
connectors or while you are cleaning the chassis.
Cleaning the Fiber-Optic Connectors
Catalyst 4900 Series Switch Installation Guide
4-7