Common User Group Settings - Cisco Servers User Manual

Chapter 6 Setting Up and Managing User Groups

Common User Group Settings

78-13751-01, Version 3.0
Cisco Secure ACS also enables you to enter and configure new TACACS+
services. For information about how to configure a new TACACS+ service to
appear on the group setup page, see the
TACACS+" section on page
You can use the Shell Command Authorization Set feature to configure TACACS+
group settings. This feature enables you to apply shell commands to a particular
user group in the following ways:
Assign a shell command authorization set, which you have previously
•
configured, for any network device.
Assign a shell command authorization set, which you have previously
•
configured, to particular NDGs.
Permit or deny specific shell commands, which you define, on a per-group
•
basis.
For more information about shell command authorization sets, see
"Setting Up and Managing Shared Profile Components."
This section presents the basic activities you perform when configuring a new
user group. This section contains the following procedures:
Enabling VoIP Support for a User Group, page 6-4
•
Setting Default Time of Day Access for a User Group, page 6-5
•
• Setting Callback Options for a User Group, page 6-6
Setting Network Access Restrictions for a User Group, page 6-7
•
• Setting Max Sessions for a User Group, page 6-11
• Setting Usage Quotas for a User Group, page 6-13
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
"Protocol Configuration Options for
3-7.
Common User Group Settings
Chapter 5,
6-3