Cisco Catalyst 2975 Hardware Installation Manual page 56

Cisco systems switch user manual

Hide thumbs Also See for Catalyst 2975:

Table of Contents

Appendix C

Configuring the Switch with the CLI-Based Setup Program

Accessing the CLI Through the Console Port

line vty 0 15

password terminal-password

no snmp-server

no ip routing

interface Vlan1

no shutdown

ip address 10.4.120.106 255.0.0.0

interface GigabitEthernet1/0/1

interface GigabitEthernet1/0/2

interface GigabitEthernet1/0/3

...<output abbreviated>

interface GigabitEthernet1/0/23

end

These choices appear:

Step 10

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it in nonvolatile

RAM (NVRAM) by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

The switch can now run the default configuration that you created. If you want to change this

configuration or want to perform other management tasks, see the

"Management Options" section on

page 1-9

for more information.

Catalyst 2975 Switch Hardware Installation Guide

C-4

OL-17784-01

Table of Contents