Cisco 600W Quick Start Manual page 13

Connect the DC-input end of the cable to a Cisco RPS rear-panel connector as shown in Figure 14 or Figure 15.
Step 3
Figure 14 Connecting a One-to-One Cable to a Cisco RPS for Quasi-Redundant Power
AC INPU T 1
AC INPU T 2
100-2 00 V~ 50/60 Hz
100-2 00 V~ 50/60 Hz
10-5 A 1000 W
10-5 A 1000 W
Figure 15 Connecting a Two-to-One Y-Cable to a Cisco RPS for Fully Redundant Power
AC INPU T 1
AC INPU T 2
100-2 00 V~ 50/60 Hz
100-2 00 V~ 50/60 Hz
10-5 A 1000 W
10-5 A 1000 W
Step 4 On the Cisco RPS rear panel, connect one or two AC power cables. A single AC power cable can go into either AC
connector. Two AC power cables provide parallel AC power sources. Use the cable locks on the Cisco RPS to lock the
cables in place. (See Figure 16.)
Figure 16 Connecting AC Power Cables to the Cisco RPS
DC OUTP UT 1
DC OUTP UT 2
DC OUTP UT 1
DC OUTP UT 2
Cable locks
DC OUTP UT 3
DC OUTP UT 4
DC OUTP UT 3
DC OUTP UT 4
13