ENGLISH (Original instructions) SPECIFICATIONS Model: XRJ05 Length of stroke 32 mm (1-1/4″) Strokes per minute High (2) 0 - 3,000 /min Low (1) 0 - 2,300 /min Max. cutting capacities Pipe 130 mm (5-1/8″) Wood 255 mm (10″) Rated voltage D.C.
Page 3
Dress properly. Do not wear loose clothing or Service jewellery. Keep your hair, clothing, and gloves Have your power tool serviced by a qualified away from moving parts. Loose clothes, jewel- repair person using only identical replacement lery or long hair can be caught in moving parts. parts.
The followings show the symbols used for tool. have been altered, may result in the battery bursting causing fires, personal injury and damage. It will volts also void the Makita warranty for the Makita tool and charger. direct current Tips for maintaining maximum...
To remove the battery cartridge, slide it from the tool Indicating the remaining battery while sliding the button on the front of the cartridge. capacity To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip Only for battery cartridges with "B"...
Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after the switch trigger is released, have the tool serviced at a Makita service center. ► 1. Shoe 2. Shoe adjusting lever NOTE: The shoe cannot be adjusted without opening the shoe adjusting lever fully.
Page 7
Hook CAUTION: When hanging the tool, set the lock/speed change lever in position to lock the switch trigger. (See the section titled “Switch action” .) CAUTION: Never hang the tool at high or potentially unstable location. ► 1. Blade clamp lever 2. Released position 3. Fixed position Insert the recipro saw blade into the blade clamp as far as it will go.
NOTE: If you remove the recipro saw blade without repairs, any other maintenance or adjustment should rotating the blade clamp lever fully, the lever may not be performed by Makita Authorized or Factory Service be locked in the released position . In this case, Centers, always using Makita replacement parts.