Attaching The Mounting Brackets; Figure 3-5 Mounting Brackets For The Cisco Ubr10012 Router - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual

Chapter 3 Installing the Cisco uBR10012 Router

Attaching the Mounting Brackets

The Cisco uBR10012 router is shipped with four mounting brackets that can be attached to either the
front or rear of the chassis, depending on your mounting preferences. The brackets can be mounted either
flush with the edge of the chassis or set back to allow the chassis to be offset mounted in the rack.
Figure 3-5
standard 19-inch equipment or telco rack:
Figure 3-5
Note The four mounting brackets shipped with the Cisco uBR10012 router are for a standard 19-inch
equipment rack or telco rack. Optional mounting brackets are orderable separately from third-party
vendors to install the chassis in a 23-inch rack.
Use the following procedure to attach the mounting brackets to the chassis.
Step 1 Determine whether you will be mounting the chassis with the front or rear facing forwards.
Determine whether you will flush-mount or offset-mount the chassis. Typically, flush-mounting is used
Step 2
for most equipment racks except for telco racks that require offset-mounting. If either style can be used,
choose the one that is most convenient for your site.
Attach two mounting brackets to each side of the chassis in the appropriate locations. The large
Step 3
mounting bracket is attached to the top of the chassis, and the smaller bracket is attached to the bottom
of the chassis.
Attach the brackets as shown in the following figures, using the screws that are supplied with the
brackets:
•
•
•
OL-18259-09
shows the mounting brackets shipped with the Cisco uBR10012 chassis for use with a
Mounting Brackets for the Cisco uBR10012 Router
Figure 3-6 shows how to attach the brackets to flush-mount the chassis with the front forwards.
Figure 3-7 shows how to attach the brackets to flush-mount the chassis with the rear forwards.
Figure 3-8 shows how to attach the brackets to offset-mount the chassis with the front forwards.
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
Attaching the Mounting Brackets
3-9