Table of Contents
Advertisement
Chapter 7
Setting Up a Device Provisioning Engine
Controls Available
These commands described in this section, provide additional configuration settings. Changing these
properties on the DPE-590 causes the change to take effect immediately, without a DPE restart. If you
are working with a lab install, and modify any DPE property, you must restart the DPE for the change
to take effect.
•
dpe.properties: /pktcbl/regsvr/configEncrypt=1
Tip
•
Tip
dpe.properties: /pktcbl/regsvr/configEncrypt=0
•
dpe.properties: /pktcbl/snmp/timeout=1 and /pktcbl/snmp/timeout=10
Tip
Debugging
Complete these steps to verify that your DPEs are operating properly after configuring them for
operation with voice technology.
Enter this command to collect all the log, property, and network configuration files on the DPE :
Step 1
support bundle state
This command places the collected log files in the /outgoing directory. From there, the bundle is
accessible using FTP.
Enter this command to check the status of both the DPE and voice technology settings:
Step 2
show dpe
Example show dpe command output
BPR Agent is running
dpe is running
Version BPR 2.5 (cbpr_25_L_200302040515).
Caching 51970 device configs and 2 external files.
Received 312 cache hits and 0 misses.
Received 0 lease updates.
Connection status is Disconnected.
Sent 77 SNMP informs and 77 SNMP sets.
Received 77 MTA provisioning successful SNMP informs.
OL-19105-01
packetcable registration encryption—This command optionally enables encryption of the MTA
configuration file.
no packetcable registration encryption—This command optionally disables encryption of the
MTA configuration file.
packetcable snmp timeout <timeout>—This command dynamically sets the number of seconds
that the DPE waits for a response to an SNMPv3 SET operation. The timeout is expressed in
seconds and the default value is 10 seconds.
Cisco Broadband Access Center for Cable Installation Guide 2.7
Debugging
7-7
Advertisement
Table of Contents
