Table of Contents
Advertisement
Chapter 3
Installing Components
Press y and Enter to create the directory and continue. The program prompts you to enter the KDC realm
Step 7
name. For example:
Key Distribution Center (KDC) Realm Name
Enter the Kerberos realm name for the KDC:
The realm name should be consistent with the realm you give to DPEs in this provisioning
group.
KDC Interface Address [10.10.10.5]
KDC FQDN [acme_u6.acme.com]
KDC Realm [ACME.COM]
The program prompts you to confirm the realm name.
Press y and Enter to confirm your entry and continue. The program prompts you to enter the KDC
Step 8
service key and the DPE panel. For example:
KDC Service Key and DPE Panel
Please Enter the Necessary Info
Enter Password Here [] 12345678901234567890
Enter Your DPE FQDN [] dpe1.cisco.com
Note
Step 9
The program prompts you to enter the information for another DPE. Press y and enter to add another
DPE, or press n and enter to continue.
Note
Step 10
Press y and Enter to continue. The program displays the installation parameters that you selected. For
example:
Installation Parameters
This screen shows the installation parameters that you have chosen:
========== Confirmation ==========
The Component Installation will use the following parameters
to install the KDC component:
KDC realm name: ACME.COM
Home directory: /opt/CSCObpr
Data directory: /var/CSCObpr
Step 11
Press y and Enter to install the KDC. The program displays a message when the installation is complete.
Caution
After installing the KDC, you must install your licenses and the chain of certificates or the KDC will not
start.
OL-19105-01
Please be aware that the service key consists of 48 characters. If all are not entered the service
key will be invalid.
The installation program uses the same voice technology shared key for all DPEs.
Cisco Broadband Access Center for Cable Installation Guide 2.7
Installing Components Using the CLI
3-15
Advertisement
Table of Contents
