Cisco 7513 Quick Start Manual page 18

Connect the RSP
Connect the Console and the
Auxiliary Y-Cables
sole terminal
The console and auxiliary Y-cables allow you to
simultaneously connect the console or auxiliary
ports on two RSP2s, RSP4s, or RSP8s to a single
console terminal or external auxiliary device. These
16
are configured as system master and slave in RSP
slots 6 and 7 in the Cisco 7513.
Step 1
Connect the DB-25 female end of the
Y-cable to the console terminal device.
Step 2
Connect one DB-25 male end of the
Y-cable to an RSP or other external
auxiliary device.
Step 3
Repeat Step 2 for the other RSP or other
external device.
external
y equipment
DB-25
Console
to cons
RSPs in
DB-25
Step 1
Connect the DB-25 male end of the
Y-cable to the external auxiliary
equipment.
Step 2
Connect one DB-25 female end of the
Y-cable to auxiliary ports on an RSP in an
RSP slot.
Step 3
Repeat Step 2 for the auxiliary ports on a
second RSP in an RSP slot.
Step 4
Connect the interface processors or VIPs
to the external network. Refer to the
appropriate processor module manual,
such as the Route Switch Processor
(RSP4/4+) Installation and Configuration
Guide.
DB-25 fe
Auxiliary
to auxili
RSPs in
DB-25 fe