Cisco 7513 Quick Start Manual page 15

Install the Hardware
Connect DC-Input Power Supply
ly
move
DC-input power su
with the terminal b
cover removed
Power leads
DC
attached to FA N O
terminal block OK
OK
(+) Positive
(–) Negative
( ) Ground
Conduit
bracket
Ca
inst
s
Warning
The system power switch on the
power supply should be off.
Step 1
Use a screwdriver to loosen and remove
the terminal block cover screws.
Step 2
Lift and remove the terminal block cover.
Step 3
Route the DC-input power cable from the
power source through the conduit bracket
on the power supply. Allow sufficient
slack in the cable.
Step 4
Attach and tighten the conduit to the
conduit bracket.
Note
The proper wiring sequence is ground to
ground, positive to positive (line to L), negative to
negative (neutral to N). The ground wire should
always be connected first and disconnected last.
13