Cisco 7507 Quick Start Manual page 31

Install Field Replaceable Units (FRUs)
Remove and Install an Interface Processor, Filler, VIP, or RSP
A
Card
carrier
Captive
guide
installation
screw
B
C
Bottom ejector lever
Card
slot
STOP!
on contact
Note
Do not shut down the system power when
removing an interface processor, VIP, or an RSP in a
system configured for high availability HA. If you
are removing an RSP and have only one RSP, shut
down the system, but first copy the configuration file
to a TFTP server. See the "Copy the Configuration
File for an RSP" section on page 32. If you have a
system using high system availability (HSA), shut
down the system to remove the master RSP, but leave
power on if you remove only the slave RSP.
Step 1
Attach an ESD-preventive wrist strap
between you and any unpainted chassis
surface.
Step 2
If you have a VIP4 and are using HSA
with an RSP2 as the slave processor,
remove the RSP2 and wait 20-30 seconds.
Step 3
Disconnect all cables from the interface
processor, VIP, or RSP port adapters;
unless you are only moving a carrier, then
skip this step.
Step 4
Use a screwdriver to loosen the captive
installation screws, as shown in A.
Step 5
Place your thumbs on both ejector levers
and simultaneously pull them both
outward, as shown in B.
Step 6
Grasp the interface processor, filler, VIP,
or RSP handle with one hand and pull the
carrier straight out of the slot, keeping
your other hand under the carrier to guide
it.
Step 7
Store the interface processor, VIP, or RSP
in an antistatic bag.
29