Cisco 7507 Quick Start Manual page 13

Cisco router quick start guide

Hide thumbs Also See for 7507:

Install the Hardware

Install Power Supplies in the Router

tive

allation

This procedure applies to AC-input and DC-input

power supplies, with differences clearly noted. Do

not mix AC-input and DC-input power supplies in

the same chassis. Install the ﬁrst power supply in the

lower power supply bay and the second, if any, in the

upper bay. In systems with dual power supplies and

separate available power sources, connect each

power supply to separate input lines—the second

power source will likely be available during a failure.

Step 1

For AC-input power supplies, conﬁrm

that the power on the power supply is off.

For DC-input power supplies, turn off the

circuit breaker to which you will connect

power, and tape the breaker switch to the

off position.

Step 2

Hold the power supply by the handle and

place your other hand underneath it.

Caution

Use two hands to remove and

install power supplies.

Step 3

Place the power supply inside the bay, and

align it to go straight into the bay.

Step 4

Push the power supply back into the bay

until its front panel is ﬂush with the

chassis rear panel.

Table of Contents