Cisco 3800 Series Quick Start Manual page 58

Connecting WAN, LAN, and Voice Cables
Figure 20
R
Figure 21
Connecting WAN, LAN, and Voice Cables
This section describes how to connect WAN, LAN, and voice interface cables to your Cisco 3800 series
integrated services router.
One Ethernet cable is provided with the router for a Gigabit Ethernet connection. These ports use
Category 5, 5e, or 6 UTP 1000BASE-T cable. Additional cables and transceivers can be ordered from
Cisco. For ordering information, see the
http://www.cisco.com/en/US/partner/products/index.html.
Connect each WAN, LAN, or voice cable to the appropriate connector on the router or on a network
module or interface card, following these precautions:
•
•
•
•
Cable connections to network modules and interface cards are described in detail in the following
documents:
•
•
Connecting Cables to Cisco 3800 Series Routers
28
RPS Connector on Cisco 3825 Router
CO MP AC
RPS connector
Connecting RPS to Cisco 3825 Router
R
Position the cables carefully, so that they do not put strain on the connectors.
Organize cables in bundles so that they do not tangle.
Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition cables
if necessary.
Install cable ties in accordance with site requirements.
Cisco Network Modules Hardware Installation Guide
Cisco Interface Cards Installation Guide
1
T FLA SH
0
SYS
AUX
ACT
RPS
IP PW R
AIM 0
AIM 1
PVD M0
PVD M1
PVD M2
PVD M3
CO MP AC
1
T FLA SH
0
SYS
SYS
ACT
PWR
AUX
RPS
PWR
AIM 0
AIM 1
PVD M0
PVD M1
PVD M2
PVD M3
Cisco Product Catalog at
OL-5970-02