Cisco 3800 Series Quick Start Manual page 133

Installing an IP Phone Power Supply
The IP phone power supply has three connectors, as shown in
Figure 72
1
2
Follow these steps to attach the power supply to the power supply tray.
Turn the tray right side up. Align the new power supply with the front wall of the tray.
Step 1
Replace and tighten the screws that hold the power supply to the tray.
Step 2
Verify that the primary power cable is connected to the motherboard as shown in
Make sure that the secondary power cable is connected to the motherboard as shown in
Install the IP phone power cable as shown in
three cable brackets, as shown in the illustration.
OL-5975-04
AC Power Supply With IP Phone Power Support
Primary power connector
Secondary power connector
3 IP phone power connector
Figure 73. Make sure that the cable is held in place by the
Installing and Upgrading Internal Components in Cisco 3800 Series Routers
Installing a Power Supply in a Cisco 3825 Router
Figure 72.
3
1
2
Figure 69.
Figure 71.
103