Cisco 7200 Series Regulatory Compliance And Safety Information Manual page 72

Site Preparation and Safety Information
•
•
Working with WAN Interfaces
•
•
•
•
•
•
•
Working with Lasers
•
•
•
Figure
shown in Figure 3and Figure 4 usually appear on field-replaceable cards. Or the larger label shown in
Figure 5 appears on the chassis.
Figure 3
CLASS 1 LASER PRODUCT
Figure 4
CLASS 1 LED PRODUCT
Regulatory Compliance and Safety Information for Cisco 7200 Series Routers
72
For DC power supplies, locate the circuit breaker on the panel board that services the DC circuit,
switch the circuit breaker to the off position, and tape the switch handle of the circuit breaker in the
off position.
Do not touch the power supply when the power cord is connected. Line voltages are present within
the power supply even when the power switch is off and the power cord is connected.
Use caution when installing or modifying telephone lines to prevent electric shock.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Do not touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Hazardous network voltages are present in WAN ports regardless of whether power to the system is
off or on. When detaching cables, detach the end away from the system first.
Do not use a telephone (unless it is the cordless type) during an electrical storm.
Do not use a telephone to report a gas leak in the vicinity of the leak.
Do not install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Fiber-optic ports (for example, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and 100BaseFX) are
considered Class 1 laser or Class 1 LED ports.
These products have been tested and found to comply with Class 1 limits of IEC 60825-1, IEC
60825-2, EN 60825-1, EN 60825-2, and 21CFR1040.
To avoid exposure to radiation, do not stare into the aperture of a fiber-optic port. Invisible radiation
might be emitted from the aperture of the port when no fiber cable is connected.
3, Figure 4, and Figure 5
Class 1 Laser Label for a Single-Mode Fiber Port
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
Class 1 LED Label for a Multimode Fiber Port
PRODUKT MIT KLASSE 1 LED
PRODUIT AVEC VOYANT DEL
DE CLASSE 1
LED
PRODUCTO LED DE LA CLASE 1
show examples of Class 1 laser and LED labels. The smaller labels
78-3419-19