Cisco 700 Series Quick Start Manual page 2

Verify the PC Setup
Before you begin, verify that each computer that will be connected to the computer has a network
interface card (NIC) installed and TCP/IP loaded.
Connect a 760 Series Router to a PC or Hub
If you are connecting the router to a computer, connect the yellow Ethernet cable from the yellow
Step 1
Ethernet port on the rear panel of the router to the Ethernet port on the network interface card on the
computer.
If you are connecting the router to a hub, connect the yellow Ethernet cable from the yellow Ethernet
port on the rear panel of the router to an Ethernet port on the hub.
CO NF IG
If you are connecting the router to a computer, to a hub, set the node-hub switch to the "NODE"
Step 2
position and connect the computers to the hub as described in the documentation provided with your
hub.
2
CO NF IG
10B AS ET
CIS CO 776
NO DE
HU B
10B AS ET
CIS CO 776
NO DE
IS DN S/
HU B
T
+5V ---1 .5A
+/-5 %
-30 V--- 0.2A
+/-2 5%
S
0
ISD N S/T
+5V ---1 .5A
+/-5 %
-30V --- 0.2A
+/-2 5%
S
0
78-10157-01