Connect The Cisco 800 Series Router To A Pc - Cisco 2800 Series Quick Start Manual

Connect the Cisco 800 Series Router to a PC

Follow these steps to connect the Cisco 800 series router to a PC:
Step 1 Connect the yellow Ethernet cable from the yellow Ethernet port (Cisco 801 and 802 routers) or from
the yellow Ethernet port with the number 0 (Cisco 803 and 804 routers) on the back panel of the router
to the Ethernet port on the NIC on the computer.
Figure 2
Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the NO HUB
Step 2
position (out). If the button is in, press it to set it to the out position.
The HUB/NO HUB button corresponds to the Ethernet port on Cisco 801 and 802 routers and to
Note
Ethernet port 0 on Cisco 803 and 804 routers.
For Cisco 803 and 804 routers, connect additional computers to the Cisco 800 series router by
Step 3
connecting Ethernet cables from the Ethernet ports labeled with the numbers 1, 2, and 3 to the Ethernet
ports on the computers.
Caution Always connect the yellow cable or Ethernet cable that you supply to the yellow ports on the router.
Do not connect the cable to an ISDN S/T or U port or to a Network Termination 1 (NT1) device.
Accidently connecting the cable to the wrong port can damage your router.
78-5374-03
Connecting a Cisco 800 Series Router to a PC
HU B
NO HU B
C is c o 8
ET HE RN
0 3
ET 10 BA
SE T
CO NS OL
E
IS DN S/
T
0
1
2
3
Cisco 803 router
PH ON E
1
2
PC
Connect the Cisco 800 Series Router to a PC
Connect the Cisco 800 Series Router to a PC
3