Installing Propeller - Yamaha F8F Owner's Manual

Maintenance
5
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
(3) Remove the
equipped), and thrust washer.
EMU46500
Dual thrust models
(1) Straighten the cotter pin and pull it out
using a pair of pliers.
(2) Remove the propeller nut, washer, and
spacer. WARNING! Do not use your
hand to hold the propeller when loos-
ening the propeller nut.
6 3
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
(3) Remove the propeller, washer, and
thrust washer.
74
1
3 2
4
propeller, washer
[EWM01891]
1
4
5
EMU30673

Installing propeller

EMU29237
Spline models
ECM00502
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
(1) Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
(2) Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
(if
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
(3) Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
3 2
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
Propeller nut tightening torque:
17 N·m (1.7 kgf·m, 13 lb·ft)
5
[ECM01882]
1
3 2
4