Advertisement
If a saw blade binds, it may walk up or kickback from the workpiece
as the saw is restarted.
Large panels tend to sag under their own weight.
Supports must be placed under the panel on both sides, near the
line of cut and near the edge of the panel.
set blades produce narrow kerf causing excessive friction, blade
binding and kickback.
cutting, it may cause binding and kickback.
The protruding blade may cut objects that can cause
kickback.
Lower guard function
If the saw is accidentally dropped,the lower guard
may be bent. Raise the lower guard with the retracting handle and
make sure it moves freely and does not touch the blade or any other
part, in all angles and depths of cut.
Lower guard may operate sluggishly due to damaged
other sawing, the lower guard should operate automatically.
coasting blade will cause the saw to walk backwards, cutting
whatever is in its path. Be aware of the time it takes for the blade to
stop after switch is released.
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS
Identify the correct saw blade to be used for the material to be cut.
than the speed marked on the tool.
Wear a dust mask.
workpieces can cause severe injury and damage.
resulting in serious personal injury. Clean the blade guards with
compressed air to ensure there is no accumulation of saw dust.
Wear proper eye and respiratory protection.
Raise the lower guard by the lever and ensure that the lower guard
returns to the original position. If the lower guard does not function
properly. Stop using the product and have it repaired.
still stalled, as doing so could trigger a sudden recoil with a high
paying heed to the safety instructions.
Remove the battery pack before starting any work on the product.
Ambient temperature range for tool during operation is between 0°C
Ambient temperature range for tool storage is between 0°C and
The recommended ambient temperature range for the charging
26
If blade adjustment shifts while
For all
An unprotected,
ENGLISH
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING!
product damage due to a short circuit, never immerse your tool,
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
protect our environment.
circuit risk).
No metal parts must be allowed to enter the battery section of the
charger (short circuit risk).
Never break open battery packs and chargers and store only in dry
Battery acid may leak from damaged batteries under extreme load
or extreme temperatures. In case of contact with battery acid wash
thoroughly for at least 10 minutes and immediately seek medical
attention.
Ambient temperature range for battery during use is between 0°C
Ambient temperature range for battery storage is between 0°C and
SPECIFIED CONDITIONS OF USE
The product is to be used with the base of the tool in contact with
ventilated area.
The product is designed for handheld use. The product is not to be
or masonry.
BATTERIES
Battery packs which have not been used for some time should be
recharged before use.
the battery pack. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and battery packs must be kept clean.
after used.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
•
away from moisture.
•
• Every six months of storage, charge the pack as normal.
TRANSPORTING LITHIUM BATTERIES
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
• The user can transport the batteries by road without further
•
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
Advertisement
