Advertisement
Quick Links
Advertisement
Related Manuals for AEG A18FCS68
Summary of Contents for AEG A18FCS68
- Page 1 A18FCS68 Original instructions...
- Page 2 Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product.
- Page 3 Handle, insulated gripping surface Lock-off button Switch trigger Rafter hook Front handle Spindle lock button Lower guard handle Bevel adjustment knob Blade Edge guide fence Blade screw Outer flange Dust pipe joint Hex key Battery port Depth adjustment lock lever...
- Page 4 START STOP...
- Page 5 90°...
- Page 6 Remove the battery pack before starting any work on the product. click...
- Page 7 75-100 % 50-75 % 25-50 % 0-25 %...
- Page 9 EN 847-1...
- Page 10 Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. 0 - 65 mm...
- Page 12 0 - 56°...
- Page 13 45° 0° 0 - 18 cm...
- Page 14 START STOP...
- Page 15 Handle (insulated gripping surface)
- Page 16 2 START 0° STOP...
- Page 17 0° > 0° 3 START STOP...
- Page 18 90° to the saw blade is necessary, use the correction screw. 0° 0° 90°...
- Page 20 ø 30 mm Always connect the dust pipe joint to the circular saw before using. Always connect the vacuum attachment to a standard vacuum hose.
- Page 21 max. 65 mm > 65 mm...
-
Page 25: Technical Data
TECHNICAL DATA A18FCS68 Type Circular saw Battery voltage 18 V Saw blade dia. x hole dia. Blade teeth Weight without battery pack Noise Information levels of the tool are: Wear ear protection! Vibration Information Cutting board WARNING! The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in accordance with a standardised test and may be used to compare one tool with another. -
Page 26: Specified Conditions Of Use
Investigate and take corrective actions to eliminate the cause of The recommended ambient temperature range for the charging blade binding. ADDITIONAL BATTERY SAFETY WARNINGS If a saw blade binds, it may walk up or kickback from the workpiece WARNING! as the saw is restarted. product damage due to a short circuit, never immerse your tool, Large panels tend to sag under their own weight. -
Page 27: Maintenance
trained persons and the process has to be accompanied by Wear a suitable dust protection mask. corresponding experts. • Ensure that battery contact terminals are protected and insulated to prevent short circuit. Wear protective gloves. • Ensure that battery pack is secured against movement within packaging. - Page 28 Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited AEG is a registered trade mark used under Unit C, 70 Business Parade South, license from AB Electrolux (publ). Highbrook, Auckland 2013, New Zealand...