Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 624

dspxgcplncons
dspxgcplncons
To display the DS0s with active xGCP connections, the number of connections for each line, and the
number of active calls for each card, use the dspxgcplncons command in the VoIP switching/trunking
and switched AAL2 PVC operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the DS0s with active xGCP connections, the number of connections
for each line, and the number of active calls for each card are displayed:
dspxgcplncons
Connections Active Line 1: 0x00bee89e
Connections Active Line 2: 0x00b5bfc5
Connections Active Line 3: 0x0015387c
Connections Active Line 4: 0x00000000
Connections Active Line 5: 0x00000000
Connections Active Line 6: 0x00000000
Connections Active Line 7: 0x00000000
Connections Active Line 8: 0x00000000
Total Active Connections: 42
The hexadecimal digits indicate the DS0s on which the connections exist. The parenthetical numbers
Note
indicate the total number of active DS0s on a line. The last line of the displayed data indicates the
total number of active connections.
Related Commands Command
delxgcpcon
dspxgcpcids
dspxgcpcon
dspxgcpcons
dspxgcpendpt
dspxgcpendptcons
dspxgcpendpts
Cisco VISM Installation and Configuration Guide
5-480
dspxgcplncons
Description
Deletes an xGCP connection specified by the xGCP connection identification
number.
Displays the LCN, CID, xGCP connection ID, endpoint name, and call ID
corresponding to each call agent established AAL2 connection on the gateway.
Displays the attributes associated with a call agent established connection.
Displays the xGCP connection ID, endpoint name and call ID corresponding
to each call agent established connection on the gateway.
Displays the attributes associated with an endpoint.
Displays the attributes of all connections associated with an endpoint.
Displays the xGCP endpoint names of all endpoints added with the addendpt
command, or the SNMP equivalent.
(15)
(16)
(11)
(0)
(0)
(0)
(0)
(0)
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands