Table of Contents
Advertisement
Connecting the Gateway to the Network
Connecting the Gateway to the Network
The Cisco Unified Videoconferencing 3545 Gateway can connect to the LAN only through the front
panel. The gateway supports a 10/100BaseT, full-duplex Ethernet interface through an RJ-45 connector.
Procedure
Connect the supplied LAN cable from your network hub to the 10/100BaseT Ethernet port on the front
Step 1
panel of the gateway. The 10/100BaseT port accepts an RJ-45 connector.
Connect a separate ISDN or serial line to each PRI or serial port in the rear panel of the gateway. The
Step 2
port accepts an RJ-45 connector.
Connecting PRI Lines to the Gateway
You must connect a PRI line to at least one Cisco Unified Videoconferencing 3545 PRI Gateway port.
The gateway supports T1 and E1 PRI configurations.
Connecting Serial Lines to the Gateway
You can connect the Cisco Unified Videoconferencing 3545 Serial Gateway to four serial lines that may
support different physical standards (V.35, RS-449 or EIA-530). The system is capable of recognizing
the type of cable connected.
Procedure
Connect the DB-60 male connector of the cable to the DB-60 female connector of the unit.
Step 1
Tighten the screws.
Step 2
Connect the remote connectors (V.35, RS-449, EIA-530 and RS-366) to the connectors or the connecting
Step 3
cable of the remote equipment
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
2-14
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 Gateway
OL-14912-01
Advertisement
Table of Contents
