Table of Contents
Advertisement
Initial Gateway Configuration
Caution
At the prompt, type N to configure default network port values and press Enter.
Step 8
At the Enter IP address for default interface prompt, type the IP address you want to assign to the
Step 9
gateway and press Enter.
Caution
At the Enter Default Router IP Address prompt, type the IP address of the router associated with the
Step 10
segment in which the unit will be installed and press Enter.
Caution
At the Enter IP Mask for default device prompt, type the subnet mask without leading zeros, and then
Step 11
press Enter. If a subnet mask is not used, press Enter.
Allow the unit to complete the reboot process. A new emulator session begins.
Step 12
Close the terminal emulator session.
Step 13
Changing the Configuration Tool Login Password
You can use the terminal emulator to change the default password of the default login user before others
can use the gateway interface.
Procedure
Start a terminal emulator session for the gateway.
Step 1
Press the RST button on the front panel of the gateway.
Step 2
After 60 seconds, a new terminal emulator session begins on the computer monitor.
Step 3
After the second VxWorks banner scrolls across the screen, the following message appears: "Press any
Key to start the configuration."
Press any key and then press Enter.
Step 4
At the prompt, enter P and press Enter to select "change the configuration software password."
Step 5
Step 6
Type the user login name for which you want to change the password and press Enter.
The default user name is admin. This is the user name that allows you to access the gateway interface.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
2-12
The network configuration Main menu displays:
Press any Key To start configuration...
Main menu
Enter <N> to configure default network port values
Enter <P> to change the configuration software password
Enter <A> to display advanced configuration menu
Enter <Q> to quit configuration menu and start GW
If you do not press a key before the countdown ends, the device continues its initialization and
you can only configure the device by pressing the RST button on the front panel.
Do not use leading zeros in the IP address.
Do not use leading zeros in the IP address.
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 Gateway
OL-14912-01
Advertisement
Table of Contents
