Specifications - Makita UB1102 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Switch trigger
2-2. Speed control screw
2-3. Higher
2-4. Lower

SPECIFICATIONS

Capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for blowing dust.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : operation without load
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
2-5. Lock button
4-1. Nozzle
4-2. Blower outlet
4-3. Pin
5-1. Dust bag
5-2. Blower outlet
Model
Air pressure
Max. air volume
No load speed
Overall length
Net weight
Safety class
noise level determined
) : 83 dB (A)
pA
) : 94 dB (A)
WA
value (tri-axial vector
2
) : 2.5 m/s
h
2
UB1102
5.7 kPa
4.1 m
16,000 min
479 mm
2.0 kg
ENE018-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-2
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG905-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
For European countries only
sum)
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Blower
Model No./ Type: UB1102, UB1103
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
3
5-3. Nozzle
5-4. Suction inlet
6-1. Fastener
7-1. Limit mark
8-1. Brush holder cap
8-2. Screwdriver
3
/min
-1
0 - 16,000 min
/II
UB1103
0 - 5.7 kPa
3
0 - 4.1 m /min
-1
479 mm
2.0 kg
/II
ENG901-1
ENH101-18