Changing The Global User Name And Password; Connecting The Cisco Unified Videoconferencing 3545 Mcu To The Lan - Cisco 3545 MCU Installation And Upgrade Manual

Cisco unified videoconferencing releases 5.6 and 5.7
Hide thumbs Also See for 3545 MCU:
Table of Contents

Advertisement

How to Perform the Initial MCU Configuration
This information appears in the SCCP Protocol Configuration dialog box in the Administrator interface.
In this dialog box, you can configure the MCU to support Cisco Unified Communications Manager as
an SCCP conference bridge

Changing the Global User Name and Password

You can change the global user name and password that the MCU uses. You use this user name and
password to access the configuration web page for the MCU, and is required for these tasks:
The default global user name is admin. The default password is <null>.
Procedure
Start a terminal emulator session as described in the
Step 1
At the prompt, enter P.
Step 2
At the Enter User name prompt, enter the name that you want to use as the global user name and press
Step 3
Enter.
At the Password prompt, enter the password that you want to use and press Enter.
Step 4
The network configuration Main menu appears.
At the network configuration Main menu, do one of the following:
Step 5

Connecting the Cisco Unified Videoconferencing 3545 MCU to the LAN

Procedure
Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front
Step 1
panel of the MCU unit. The 10/100BaseT port accepts an RJ-45 connector.
Step 2
Turn on the power to the MCU unit.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
2-22
Enter the letter for the set of parameters that you want to configure.
Enter Q to save your changes and allow the device to complete the boot process.
Starting a Telnet session to monitor the MCU
Upgrading the MCU software
Uploading Interactive Voice Response (IVR) messages to MCU configuration memory
Enter the letter for the set of parameters that you want to configure.
Enter Q to save your changes and allow the device to complete the boot process.
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 MCU
"Setting the IP Address" section on page
2-18.
OL-17013-01

Advertisement

Table of Contents
loading

Table of Contents