Table of Contents
Advertisement
How to Perform the Video Processing Module Initial Configuration
Configuration of any of the parameters other than N: Configure default network port values may alter
Caution
the function of the device and should not be performed by an unauthorized person.
Changing the Configuration Software Password
You can use the serial port to change the configuration software password.
Procedure
At the prompt, enter P to change the configuration software password and press Enter.
Step 1
The user profile screen appears as follows:
At the Enter user name prompt, enter the new user name and press Enter.
Step 2
Step 3
At the Enter user password prompt, enter the new password and press any key to return to the video
processing module Main menu.
Changing the Security Level
You can use the serial port to change the security level. Security levels are as follows:
•
•
•
Procedure
Step 1
At the prompt, enter S to configure the network security level and press Enter.
The security level screen appears as follows:
Enter the new security level required and press Enter.
Step 2
The updated security level screen appears as follows:
The video processing module Main menu displays.
Step 3
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
2-10
Enter user name:
Enter new password:
0 (low)—Allows SNMP, Telnet, HTTP, FTP, and ICMP to access the MCU.
1 (medium)—Allows access to the MCU only through SNMP, HTTP and ICMP.
2 (high)—Allows only HTTP to access the MCU.
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
2
Board security level changing to [2 high]:
Set icmpRequestBlock to 2
The new security level is [2 high].
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
OL-17012-01
Advertisement
Table of Contents
