Table of Contents
Advertisement
Servicing the GPU Module
Step 1
Locate the retaining clips on the filler blank (2, in the illustration). Each side of the filler blank has a retaining clip.
Step 2
Grasping the filler blank by the bracket, align the filler blank with the GPU slot.
Step 3
Holding the filler blank level, slide it into the GPU slot until the retaining clips fit into place behind the sheet metal wall
of the GPU cage (1).
Step 4
Make sure that the tab on the filler bracket sits flush in the GPU slot.
What to do next
Reinsert the GPU cage onto the front mezzanine GPU module.
Replacing a Drive
The front mezzanine GPU module supports up to two U.2 NVMe drives. Each drive is front-loading into the
front of the module.
Use the following tasks to replace a U.2 drive.
•
•
Removing a Drive, on page 22
Installing a Drive, on page 23
Cisco UCS X10c Front Mezzanine GPU Module Installation and Service Guide
Replacing a Drive
Installing a GPU Cage, on page 16
21
Advertisement
Table of Contents
