Touch Panel Calibration - Pioneer AVH-P6500DVD UC Service Manual

5
6.9 TOUCH PANEL CALIBLATION

1. Touch panel calibration

1.1 To enter the touch panel calibration mode
While pressing the ATT and BACK keys on the main unit, reset and start the unit.
1.2 Adjustment outline
1) Touch panel effective range check
2) Touch panel 16-point calibration
The touch panel calibration consists of the above two checks.
When finishing the above checks, exit from the calibration mode by turning off the ACC.
1.3 Adjustment screen menu
Top menu
1) Setup TP effective range
The effective range (outer limit) of the touch panel is obtained.
2) Setup calibration
By touching the 16 points on the screen (excluding the last one for finalization), whole screen calibration will be per-
formed.
* Pressing any screen points far from the (+) marks will not allow you to proceed to the next (+) point.
* To stop the calibration, press the BAND/ESC key.
3) Touch-panel test (only for factory test)
For each (+) mark, the OSD coordinates, AD values, and coordinates before and after correction are displayed.
4) Calibration test (only for factory test)
For touched points, coordinates before and after correction are displayed.
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
0
# # # C a l i b r a t i o n / T P - T E S T # # #
1
1 . S e t u p T P e f f e c t i v e r a n g e
2
2 . S e t u p c a l i b r a t i o n
3
3 . To u c h - p a n e l t e s t
4
4 . C a l i b r a t i o n t e s t
5
6
[ E N T E R ]
7
[ U P / D O W N ]
8
[ A C C O F F ]
9
1.4 Cautions on adjustment
1) Be sure to perform the touch panel effective range check (1.Setup TP effective range) first, and then the touch panel
16-point calibration (2. Setup calibration). If the TP effective range check is done again after the TP 16-point calibration,
you need to perform the 16-point calibration again.
2) At the TP effective range check, never use a pointed thing like nails to trace the edge of the screen. Use a round-
headed thing (R1 or more) and push the screen softly to prevent the screen from being damaged.
1.5 Detailed adjustment procedures
On the main unit or the remote control, use the UP/DOWN keys to select the check item (1) or (2) from the menu, and
then press the ENTER key.
When finishing both checks, turn off the ACC to exit from the calibration mode.
5
6
M e n u s e l e c t i o n
C u r s o r m o v e m e n t
E n d o f t e s t
AVH-P6500DVD/UC
6
7
0
1
2
3
4
5
6
7
8
9
7
8
A
B
C
D
E
F
163
8