Ending A Call; Using Hold And Resume - Cisco 7945G User Manual

Ending a Call

To end a call, hang up. Here are some more details.
If you want to...
Hang up while using the handset
Hang up while using a wired headset
Hang up while using the speakerphone Press
Hang up one call, but preserve another
call on the same line

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
caller ID and the corresponding line button flashes green
If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts back to
ringing after a certain period of time. The 'reverting' call remains on hold until you resume it or until
Hold Reversion times out.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a flashing amber line button
If you want to...
Put a call on hold
Remove a call from
hold on the current line
Cisco Unified IP Phone 7965G and 7945G Phone Guide for Cisco Unified Communications Manager 7.0
Then...
Return the handset to its cradle. Or press EndCall.
Press
If you are using a wireless headset, refer to the wireless
headset documentation.
Press EndCall. If necessary, remove the call from hold first.
Then...
1. Make sure the appropriate call is highlighted.
2. Press Hold.
1. Make sure the appropriate call is highlighted.
2. Press Resume.
. Or, to keep headset mode active, press EndCall.
or EndCall.
.
next to the caller ID for the held call.
(depending on the line state).
appears next to the
25