Table of Contents
Advertisement
BEFORE USE
IMPORTANT - For your convenience, we have included 4 "AA" Batteries that provide the power for
the electronic keypad. These must be installed before using your box. If your safe is locked, you
may use the Emergency Key to open it. The starter batteries included with this product are for testing
purposes only and should be immediately replaced with new alkaline or lithium batteries. It is NOT
RECOMMENDED to use Non-alkaline or rechargeable batteries.
SETUP & OPERATION (STEP 1)
1. Remove the Black Emergency Key Cover. (Figure 1).
2. Insert the Emergency key and turn ¼ turn to the left (counterclockwise) (Figure 2).
3. Turn the Open/Close knob ¼ turn to the left (counterclockwise) and open the lid. (Figure 3).
4. Remove the Battery Compartment cover by pushing in and sliding down (Figure 4).
5. Install the batteries as pictured on the inside of the Battery compartment. Ensure the batteries are
installed in the correct direction, with regard to polarity (+ and -)
6. Once the batteries are properly installed, replace the battery compartment cover. Close lid and
return Knob & Key to "Locked" position and replace Emergency key cover.
Figure 1
Figure 1
NOTE: If batteries are removed or fail, the keypad memory will NOT be erased and the active
programmed code will still work once power has been restored.
Weak or dead batteries should be replaced immediately and all 4 batteries should be changed. To
replace the batteries please follow the instructions in the SETUP section. Remember to always remove
batteries from safe if not using for an extended period of time. If your batteries are completely dead
and you cannot open the safe by using the digital keypad, use the override access key to open safe
and access the battery compartment.
Figure 2
+
+
-
-
AA
AA
+
-
+
-
Figure 2
Figure 3
Figure 3
3
Advertisement
Table of Contents
