Standard Settings - Hitachi CMP205SXE Service Manual

STANDARD SETTINGS

Microprocessor-based preset functions can store adjusted settings.
The industrial standard settings have been pre-programmed by the factory.
Pre-programmed settings are as follows. In addition, more 15 user settings can be stored.
Display mode Resolution
NEC 640x400-56 640
VGA-60 640
VGA-72/VESA 640
VGA-75/VESA 640
Mac13"-67 640
SVGA-56/VESA 800
SVGA-60/VESA 800
SVGA-72/VESA 800
SVGA-75/VESA 800
Mac16"-75 832
XGA-60/VESA 1024 x 768 48.36 kHz
XGA-70/VESA 1024 x 768 56.48 kHz
Mac19"-75 1024 x 768 60.06 kHz
XGA-75/VESA 1024 x 768 60.02 kHz
1152x864-75/VESA 1152 x 864 67.50 kHz
1280x960-60/VESA 1280 x 960 60.00 kHz
* SXGA-60/VESA 1280 x 1024 63.98 kHz
SXGA-75/VESA 1280 x 1024 79.98 kHz
*SXGA-60/VESA is standard recommended timing.
Note:
Input signals with approximately the same frequencies may be regarded as the same signal.
Timing and/or display positions might be shifted in case of connection with some equipment. In that case,
please refer to "Display Adjustment".
Standard settings are subject to change without notice.
H-frequency V-frequency Sync-polarity Scanning mode
x 400 24.83 kHz 56.42 Hz
x 480 31.47 kHz 59.94 Hz
x 480 37.86 kHz 72.81 Hz
x 480 37.50 kHz 75.00 Hz
x 480 35.00 kHz 66.67 Hz
x 600 35.16 kHz 56.25 Hz
x 600 37.88 kHz 60.32 Hz
x 600 48.08 kHz 72.19 Hz
x 600 46.88 kHz 75.00 Hz
x 624 49.67 kHz 74.47 Hz
60.00 Hz
70.07 Hz
74.70 Hz
75.03 Hz
75.00 Hz
60.00 Hz
60.02 Hz
75.03 Hz
Both of positive
Non-Interlaced
& negative
10