Table of Contents
Advertisement
Using a DSP
A DSP (Digital Signal Processor) is a type of effect that is
connected between the sound source and output. Included
are equalizer, tremolo, limiter, wah, etc. In addition to the
default DSPs*
1
assigned to each of the tones, your Digital
Piano also offers a selection of 100 preset DSPs*
to choose. You can also configure DSP parameter settings.
*1 DSPs that are pre-assigned to each tone based on
suitability. Some tones do not have a default DSP
assigned.
*2 DSP in addition to the default DSPs, which can be
assigned to any tone.
■ To select a DSP
1.
Use the procedure under
(page EN-15) to select a tone.
2.
Use the bp^ button to cycle through settings
until the "^CTRL" indicator to the right of the
button is lit.
3.
Touch bq DSP.
This displays the name of the DSP assigned to the tone
you selected (Upper1 tone) in step 1 of this procedure.
• If the current DSP is the default, the word "Tone" will
be shown on the display.
[
C T R L
]
D S P
0 0 0 : T o n e
T : 1 2 0
4.
Use the bk – and bl + buttons to select a DSP.
• For the names of all the selectable preset DSPs and
their contents (DSP modules), see
(page EN-79). For information about DSP modules,
see
"Configuring DSP
• To return to the initial default DSP, touch bk – and
bl + at the same time.
• Even if layer and/or split is enabled, the display that
appears in step 3 above shows the name of the DSP
assigned to Upper1 tone.
2
from which
"To select a
tone"
"Preset DSP
Settings" (page EN-23).
■ Configuring DSP Settings
The steps below are the general procedure for configuring
DSP settings.
(1) Select the default DSP or preset DSP whose settings you
want to configure.
(2) Select one of the DSP modules in the DSP you selected.
(3) Configure the settings of the parameters in the DSP
module you selected.
● Example: One DSP module: Preset DSP No.1
"Mono 1BandEQ"
Sound Source
● Example: Four DSP modules: Preset DSP No.27
"Re-Amp 1"
Sound Source
If the DSP whose settings you are configuring consists of four
modules and you want to change all of their settings, repeat
steps (2) and (3) four times, once for each module. For details
on the full procedure, see
EN-24).
• Note that any changes you make to DSP settings are
cleared whenever you turn off Digital Piano power. If
you want to retain DSP changes you make, use the
registration function (page EN-40) to save the setup so
you can recall it later.
List"
Digital Piano Operations
Mono 1EQ
Compressor
Amp Cab
Enhancer
ToneCtrl
"To configure DSP
Output
Output
settings" (page
EN-23
Advertisement
Table of Contents
