Motion Decay Settings - Sony XKS-C9111 User Manual

No. Parameter Adjustment
1 Defocus V Degree of defocusing of the video
signal
2 Defocus K Degree of defocusing of the key
signal
To turn the afterimage portion into stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >Trail menu (4152), press
[Dust], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Trail Dust Amount of the afterimage
disappearing as stardust
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Dust Aspect Aspect ratio of stardust
a) The way in which the afterimage disappears is affected by both the
trail [Decay] and [Trail Dust] parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the
combine.
Notes
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Trail effect only
is applied, regardless of the selection in the <Combine
Process> group.
In the <Combine Process> group of the DME >Light/Trail
>Trail menu (4152), select one of the following.
Combine −> Trail: Add the Trail effect after the combine.
The parameter data for the channel with the lowest
number among the channels being combined is
enabled.
Trail −> Combine: Add the Trail effect before the
combine. Parameters can be set independently for each
channel.
Combine −> Trail

Motion Decay Settings

Note
Enabling Motion Decay automatically disables Trail,
Keyframe Strobe, or Wind if it is set.
a)
Applying the Motion Decay effect
1
Open the DME >Light/Trail >Motion Decay menu
(4153).
2
Press [Motion Decay], turning it on.
3
Set the following parameter.
No. Parameter
1 Video
Decay
a) 0.00 represents no afterimage. 100.00 represents no decay in the
afterimage.
4
In the <Decay Mix Mode> group, select the way in
which the video signal is blurred.
Soft: Mix the live image and the afterimage.
Hard: Show the brighter parts of the live image and
afterimage.
Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the DME >Light/Trail >Motion Decay menu (4153),
press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group of the DME >Light/
Trail >Motion Decay menu (4153), select the timing for
freezing motion decay.
Frame: Freeze in frame units.
264
Trail −> Combine
Adjustment
Degree of decay of the video signal
a)