Rotation Settings; Virtual Image Cancelation - Sony XKS-C9111 User Manual

4
Select the function to be set.
To change the aspect ratio of the key: Press the [ASP
PERS] button, turning it on.
To reduce/enlarge or move the key: Press the [LOC
SIZE] button, turning it on.
To rotate or change the perspective of the key:
Press the [ROT] button, turning it on. To specify
the direction of rotation, press the [X] button or
[Y] button. To adjust perspective, press the [Z]
button.
5
Use the trackball or Z-ring for the operation.
Pressing the [FINE] button, turning it on, enables fine
adjustment of setting values (fine mode).
Pressing the [X], [Y], or [Z] button, turning it on,
restricts operation to the selected axis or item.
The target bank and resizer, and the current parameter
and its value, are displayed in the display of the device
control block.
The functions assignable to trackball and Z-ring
operations are shown in the following table.
Operation Trackball
buttons (horizontal
(Parameter) rotation)
[X] button
ASP PERS Change
(ASP) aspect ratio
on X-axis
LOC SIZE Move image
(LOC SIZE) on X-axis
ROT Rotate
(ROT PERS) image on Y-
axis
To enter parameters
Operates identically to DME three-dimensional parameter
input.
For details, see "Three-Dimensional Parameter Entry"
(page 228).
To reset parameters
Operates identically to DME three-dimensional parameter
reset.
For details, see "Resetting three-dimensional
parameters" (page 228).
To return the resizer to default state (clear work
buffer)
To clear and reset to default state only the two-dimensional
transform and rotation parameters contained in the work
buffer, depending on the resizer operation, press the [CLR
WORK BUFR] button in the device control block.
Trackball Z-ring
(vertical
rotation)
[Y] button [Z] button
Change Change aspect ratio
aspect ratio on X- and Y-axes
on Y-axis simultaneously
Move image Magnify and shrink
on Y-axis image
Rotate Change distance of
image on X- viewpoint position
axis
To clear all of the parameters in the work buffer and reset
the resizer, press the [CLR WORK BUFR] button twice in
rapid succession.
For the default state, you can select either the factory
default settings or user settings.
For details, see "Power-On (Startup) State Selection"
(page 398).
To reset the bank to the default state
Press the [M/E DEF RCALL] button twice in rapid
succession to return the currently selected bank (M/E or
PGM/PST) to the default state.

Rotation Settings

Note
Select either X or Y direction for rotation. You cannot
make rotation by combining both directions.
1
In the M/E-1 >Key1 >Resizer menu (1115), press
[Resizer], turning it on.
2
In the <Resizer Effect/Rotation> group, press
[Rotation].
The Rotation menu (1115.5) appears.
3
In the <Rotation> group, select the direction of
rotation.
X: Horizontal rotation
Y: Vertical rotation
4
Set the following parameters.
When [X] is selected
No. Parameter Adjustment
1 Rotation X
4 Perspective Perspective
When [Y] is selected
No. Parameter Adjustment
2 Rotation Y
4 Perspective Perspective

Virtual Image Cancelation

If an extreme degree of perspective is set for an image, the
part of the image exceeding the virtual view point is
displayed wrapped around on the monitor screen. This is
referred to as a virtual image.
You can make a setting so as not to show the virtual
images.
132
Horizontal key rotation
Vertical key rotation