Table of Contents
Advertisement
If you touch
while you set the
DURATION, the
appliance switches to
the setting of the END
function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display.
The appliance deactivates.
7. Touch a sensor field or open the
oven door to stop the acoustic
signal.
8. Deactivate the appliance.
7.4 Setting the END
1. Activate the appliance and set an
oven function and temperature.
2. Touch
again and again until the
display shows
flashes in the display.
3. Use
or
to set the END and
or
to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes.
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
5. Deactivate the appliance.
7.5 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a
programme) and temperature (refer
to "Setting the oven function" and
"Changing the temperature").
2. Set the DURATION (refer to "Setting
the DURATION").
3. Touch
again and again until
flashes in the display.
4. Touch
to set the SET+GO
function.
The display shows
indicator. This indicator shows which
clock function is activated.
or
.
symbol
and
with an
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
7.6 Setting the MINUTE
MINDER
Use the MINUTE MINDER to set a
countdown (maximum 23 h 59 min). This
function has no effect on the operation
of the oven. You can set the MINUTE
MINDER at any time and also when the
appliance is off.
1. Touch
.
and "00" flash in the display.
2. Use
to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Use
or
to set the MINUTE
MINDER and
4. Touch both
reset the set time.
5. Touch
or the MINUTE MINDER
starts automatically after five
seconds.
When the set time ends, an acoustic
signal sounds for two minutes and 00:00
and
flash in the display.
6. Touch a sensor field or open the
oven door to stop the acoustic
signal.
7.7 Setting the Time delay
function
The DURATION
used at the same time, if the appliance is
to be switched on and off automatically
later. In this case, first set the DURATION
and then the END
to "Setting the DURATION" and
"Setting the END" ).
When the Time delay
function is activated, the
display shows a static
symbol of the oven function,
with a dot and
dot shows which clock
function is on in the Clock /
residual heat display.
ENGLISH
15
to confirm.
and
at once to
and END
can be
function (refer
. The
Advertisement
Table of Contents
