Advertisement
all instructions.
Clear the work area before each use. Remove all objects, such
as cords, lights, wires, or strings which can be thrown or become
entangled in the cutting means.
Check the hedge for foreign objects, such as wire fences.
Exercise additional caution when using the product near posts,
buildings, or other immovable objects.
Beware of thrown objects; keep all bystanders, children, and pets at
least 15 m away from work area.
Do not allow children or untrained individuals to use the product.
Do not operate in poor lighting. The operator requires a clear view
of the work area to identify potential hazards.
Ensure all handles and guards are fitted when using the hedge
trimmer. Never attempt to use an incomplete hedge trimmer or one
fitted with an unauthorised modification.
Ensure before each use that all controls and safety devices function
correctly. Do not use the product if the "off" switch does not stop
the product.
Inspect the product before each use. Check for loose fasteners.
Make sure all guards and handles are properly and securely
attached. Replace any damaged parts before use. Check for battery
pack leaks.
Do not modify the product in any way.
Wear full eye and hearing protection while operating the product.
If working in an area where there is a risk of falling objects, head
protection must be worn.
Wear heavy, long trousers, boots, and gloves. Do not wear loose
fitting clothing, short trousers, jewellery of any kind, or use with bare
feet.
Secure long hair so it is above shoulder level to prevent
entanglement in moving parts.
Use of hearing protection reduces the ability to hear warnings
(shouts or alarms). The operator must pay extra attention to what is
going on in the working area.
Operating similar tools nearby increases both the risk of hearing
injury and the potential for other persons to enter your working area.
Do not use the product when you are tired, ill, or under the influence
of alcohol, drugs, or medication.
Keep firm footing and balance. Do not overreach. Overreaching can
result in loss of balance and can result in serious injury.
Keep all parts of your body away from any moving part.
Before starting the product, make sure the cutting blades will not
come in contact with anything.
While operating the hedge trimmer, always hold it firmly with both
hands by the two handles. Ensure that the operating position is
safe and secure. The manufacturer does not recommend the use
of steps or ladders. If higher trimming is required, use an extended-
reach tool.
Blades are sharp. When handling the blade assembly, wear non-
slip, heavy duty, protective gloves. Do not place your hand or
fingers between blades or in any position where they could get
pinched or cut. Never touch the blade or service the product unless
the battery pack is removed.
Switch off and remove the battery pack. Make sure all move parts
have come to a complete stop:
■
before leaving the product unattended
■
before cleaning or clearing a blockage
■
before adjusting the working position of the cutting means
■
before checking, conducting maintenance, or working on the
product
Do not force the product through heavy shrubbery. This can cause
the blades to bind and slow down. If the blades slow down, reduce
the pace.
Do not attempt to cut stems or twigs that are larger than 10 mm
thick, or those obviously too large to feed into the cutting blade.
Use a non-powered hand saw or pruning saw to trim large stems.
Do not operate the product with damaged or excessively worn
blades.
WARNING! If the product is dropped, suffers heavy impact,
or begins to vibrate abnormally, immediately stop the product
and inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replaced by an
authorised service centre.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING! To reduce the risk of fire, personal injury, and
product damage due to a short circuit, never immerse your
tool, battery pack or charger in fluid or allow a fluid to flow
inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing
products, etc., can cause a short circuit.
TRANSPORTATION AND STORAGE
Stop the product, remove the battery, and allow it to cool before
storing or transporting.
Clean all foreign materials from the product. Store the product in a
cool, dry, and well-ventilated place that is inaccessible to children.
Keep away from corrosive agents, such as garden chemicals and
de-icing salts. Do not store outdoors.
Cover the blade with the blade protector before storing the product,
or during transportation.
For transportation in vehicles, secure the product against movement
or falling to prevent injury to persons or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling when
transporting batteries by a third party. Ensure that no batteries can
come in contact with other batteries or conductive materials while
in transport by protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries that are cracked
or leaking. Check with the forwarding company for further advice.
MAINTENANCE
WARNING! Use only original manufacturer's replacement
parts, accessories, and attachments. Failure to do so can cause
possible injury and poor performance, and may void your warranty.
WARNING! Servicing requires extreme care and knowledge
and should be performed only by a qualified service technician.
Have the product serviced by an authorised service centre only.
When servicing, use only identical replacement parts.
WARNING! The blades are extremely sharp. To prevent
personal injury, exercise extreme caution when cleaning, lubricating
and fitting or removing the blade protector.
Remove the battery .before adjusting, maintaining, or cleaning the
product.
You may only make adjustments and repairs described in this
manual. For other repairs, contact an authorised service agent.
After each use, clean the body and handles of the product with a
soft, dry cloth.
After each use, clean the debris from the blades with a stiff brush,
21
21
Advertisement
