Page 2
mportant! It is essential that you read the instructions in this manual before assembling, operating, and maintaining the product. Subject to technical modifications.
INSTALLING/UNINSTALLING THE HANGER INSTALLING THE ATTACHMENT STORING THE PRODUCT...
Page 6
INSTALLING/UNINSTALLING THE HANGER click...
Page 7
INSTALLING THE ATTACHMENT NOTE: Ensure that the inner shafts are seated together correctly to prevent damage and ensure normal function of the click product. Always ensure that the location pin is correctly located in the guide hole.
TECHNICAL DATA EDGER ATTACHMENT AEDG10 Blade swath 204 mm No load blade speed (58V AEG power head) High speed (maximum) 4600 min area Low speed (maximum) 4000 min by a No load blade speed(18V AEG power head) High speed (maximum)
Page 17
INTENDED USE protection. Protective equipment such as a dust mask, non- The edger attachment is approved for use with 18V AEG ALT18B skid safety shoes, hard hat or hearing protection used for power head and 58V AEG ALT58B / ALT58BT power head.
Page 18
■ Keep handles and grasping surfaces dry, clean and free from ■ Keep bystanders, children, and pets 15 m away from the area of oil and grease. Slippery handles and grasping surfaces do not operation. Turn off the product if anyone enters the area. ■...
■ Servicing requires extreme care and knowledge and should ADDITIONAL SAFETY WARNINGS a of be performed only by a qualified service technician. Have the ■ Some regions have regulations that restrict the use of the product serviced by an authorised service centre only. When product.
Page 20
Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited AEG is a registered trade mark used under Unit C, 70 Business Parade South, license from AB Electrolux (publ). Highbrook, Auckland 2013, New Zealand AEG is a registered trademark used under license from AB Electrolux (publ).