Mvme712M Transition Module; P2 Adapter Board - Motorola MVME712C Installation And Use Manual

General Information
1

MVME712M Transition Module

P2 Adapter Board

1-2
The features of the MVME712M include:
Four 25-pin multiprotocol EIA-232-D serial ports
(through P2 adapter)
One independent printer port (through P2 adapter)
Small Computer Systems Interface (SCSI) shielded connector bus
interface (through P2 adapter) for connection to internal and
external devices
Green LED on module to indicate terminator power
Yellow LED on module to indicate transceiver power
SCSI terminating resistors mounted in sockets for end of cable or
middle of cable configuration
Modem connection on module
Radio Frequency Interference (RFI) protection on front panel
Electrostatic Discharge (ESD) protection on front panel
The MVME712M requires the use of the P2 adapter board. The features of
the P2 adapter board include:
A connector that permits SCSI cable connection to other SCSI
devices and/or to MVME712M through a flat ribbon cable
SCSI terminating resistors mounted in sockets, for end of cable or
middle of cable configuration
Terminator power developed on the P2 adapter from the
+5 Vdc on connector P2, and fused (1 A) on the P2 adapter
A connector that interfaces the EIA-232-D ports, printer port, SCSI,
and Ethernet signals to the MVME712M
Computer Group Literature Center Web Site