Cables And Connectors; Table 2-3. Cables And Connectors - Motorola MVME712C Installation And Use Manual

Cables and Connectors

The MVME712M front panel has four serial ports, one printer port, one
SCSI port, and one Ethernet port. The connectors for these ports, the P2
backplane connector, and two modem connectors are described in the
following table. The P2 adapter board's MVME712M connector, P2
connector, and SCSI connector are also described in the table.
Cables recommended for use with the connectors are also listed in the
table. Note that not all peripheral cables needed are provided with the
MVME712M. You may need to fabricate or purchase certain cables.
1
Port Connector
Serial ports J7 through J10 25-pin female DB-25 connectors
1 through 4
Printer port J5
Ethernet port J6
SCSI Interface J4
port
Interconnection Connector
SCSI J3
http://www.mcg.mot.com/literature

Table 2-3. Cables and connectors

MVME712M Board Front Panel
Description
that cable to your serial devices
36-pin female connector that
cables to your printer
15-pin female DB-15 connector
that cables to your Ethernet
network controller, or connects
to an adapter box
50-pin female connector that
cables to your SCSI devices
MVME712M Board Top Side
Description
50-pin male IDC connector that
cables to J3 on the P2 adapter
board and/or to SCSI devices, in
almost all configurations
Cables and Connectors
Cable
User-supplied serial
EIA-232-D DTE or DCE cable
(pins used depend upon the
processor VMEmodule)
User-supplied Centronics-type
parallel printer cable, male-to-male
User-supplied network cable or
user-supplied adapter box to
convert to another medium
User-supplied 50-conductor cable
with SCSI connector(s) as needed
Cable
Part number 30-W2960B01A.
17.5-inch, 50-conductor flat-ribbon
cable furnished with the
MVME712M, used only in the
external-SCSI-only configuration
labeled Configuration E in
4 and Figure 2-18. Otherwise, a
user-supplied 50-conductor cable
with SCSI connector(s) as needed
2
Table 2-
2-15