Table of Contents
Advertisement
R
ECEIVING
1 Select the desired zone and channel using the GRP
CH control.
2
• If the vibrator function is on, the transceiver will vibrate when a call is received.
• If signaling has been programmed on the selected channel, you will hear a call only
if the signal tone matches the tone set up on your transceiver.
Note: Signaling allows your transceiver to code your calls. This will prevent you from listening
to unwanted calls. It does not make calls private, it only prevents them from being heard by
transceivers set with a different signaling code. Refer to "SIGNALING" on page 27 for details.
R
G
ECEIVING
ROUP
When you receive a group call on a Conventional channel and the received
voice.
When you receive a group call on a Trunking channel, the transceiver
• Readjust the volume as necessary.
R
I
ECEIVING
NDIVIDUAL
When you receive an individual call on a Conventional channel, a ringing tone
press and hold the microphone PTT switch and speak into the transceiver as
you would during a normal transmission.
When you receive an individual call on a Trunking channel, a ringing tone will
To receive the call, press the PTT switch. To deny the call, press and hold the
PF 1 key or the keypad # key. After receiving the call, you can respond to the
call by pressing and holding the PTT switch and speaking into the microphone
PF 1 key or the keypad # key to end the call.
14
C
(P25)
ALLS
C
(P25)
ALLS
and
keys and the
Advertisement
Table of Contents
