Makita 9237CX3 Instruction Manual page 7

1 2
003448
Always install the loop handle on the tool before
operation. Hold the tool's switch handle and the loop
handle firmly with both hands during operation.
Install the loop handle so that its protrusion will fit into
the matching hole in the gear housing.
Install the bolts and tighten them with the hex wrench.
The loop handle can be installed in two different
directions as shown in the figures whichever is
convenient for your work.
1
2
003449
1 1
2
003450
Installing side grip (handle)
(optional accessory)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
1. Protrusion of
loop handle
2. Matching hole
in gear housing
1. Loop handle
2. Hex wrench
3. Bolt
3
1. Loop handle
3 2. Bolt
3. Hex wrench
003805
For tools which are equipped with a backing
pad.
Installing or removing the wool pad
(optional accessory)
1
2
3
015202
To install the wool pad, first remove all dirt or foreign
matter from the backing pad. Press the shaft lock and
screw the backing pad onto the spindle. Insert the
sleeve 18 into the center hole of the backing pad.
Using the sleeve 18 as a positioning guide, install the
wool pad on the backing pad with the sleeve 18 inserted
through the center hole of the wool pad. Then remove
the sleeve 18 from the backing pad.
To remove the wool pad, just tear it off the backing pad.
Then unscrew the backing pad while pressing the shaft
lock.
For tools which are equipped with a rubber
pad.
Installing or removing the wool bonnet
(optional accessory)
3
014939
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
7
1. Wool pad
2. Sleeve 18
3. Backing pad
4. Spindle
5. Shaft lock
4
5
1. Wool bonnet
1
2. Lock nut
2
3. Rubber pad
4. Spindle
4
5. Shaft lock
5