Appendix F- Rs232 Communications (If Equipped) - Omega HHF143 User Manual

APPENDIX F- RS232 COMMUNICATIONS (IF EQUIPPED)

If the instrument is equipped with the RS232 Communications option,
there will be a three pin male connector on the bottom of the instrument.
Also, an RS232 cable will be included with the instrument. This cable
will have a three pin female connector on one end and a 089 Female
connector on the other end.
RS232 Data Output - Instructions for Use
STEP 1 : Connect the RS232 cable (included) to the, female connector
on the bottom of your instrument. Connect the other end to an
RS232 port on your computer.
STEP 3: Turn the Instrument ON.
STEP 4: Verify that the Instrument has been set up as a RS232 Serial
Port with a unique COM port number. (You only need to do
this once). For Windows users, open the Windows Device
Manager (found in Control Panel) and veriify that a serial port
exists.
You are now ready to capture the data being measured by
your instrument.
Please refer to Appendix G - Viewing and Capturing Data
for further instructions.
Rev 1.8, 10-Jun-2008
Page 15 of24