Appendix E - Rs232 Communications (Ii� Equipped) - Omega HHF142 User Manual

APPENDIX E - RS232 COMMUNICATIONS (II� EQUIPPED)
If the instrument is equipped with the RS232 Communications option,
there will be a three pin male connector on the bottom of the instrument.
will
Also, an RS232 cable
will have a three pin female connector on one end and a 0B9 Female
connector on the other end.
RS232 Data Output - Instructions for Use
STEP 1: Connect the RS232 cable (included) to the female connector
on the bottom of your instrument. Connect the other end to an
RS232 port on your computer.
STEP 3: Turn the Instrument ON.
STEP 4: Verify that the Instrument has been set up as a RS232 Serial
Port with a unique COM port number. (You only need to do
this once). For Windows users, open the Windows Device
Manager (found in Control Panel) and verify that a serial port
exists.
You are now ready to capture the data being measured by
your instrument.
Please refer to Appendix F - Viewing and Capturing Data
for further instructions.
be included with the instrument. This cable
Rev 1.9, 1 0-Jun-2008
Page 19 of 28